Home. About Me. Contact. Products. Feedback. Links.
INSTRUCTIONS FOR USE
50 to 60 CONVERTER
ALL HIGH POWER TYPES
1. ON MACHINES THAT USE A TWO PIN AMERICAN STYLE PLUG BETWEEN THE TURNTABLE MOTOR AND THE CONTROL CENTRE, INSERT THE CONVERTER INTO THE LINE USING THE PLUG/SOCKET PROVIDED ON THE CONVERTER.
2. FOR OTHER MACHINES USING HARD WIRED OR NON TWO PIN PLUGS, LOCATE THE LIVE WIRE PAIR FEEDING THE TURNTABLE MOTOR AND CUT THIS PAIR.
3. YOU WILL NOW HAVE FOUR WIRE ENDS(A FEED PAIR AND A MOTOR PAIR) SOLDER OR CRIMP/SPLICE THE FEED PAIR INTO THE BROWN AND BLUE WIRES OF THE CONVERTER. (MARKED 110VOLT 50HZ INPUT).
4. SOLDER OR CRIMP/SPLICE THE MOTOR PAIR INTO THE BLUE AND BROWN (BLUE AND RED ON SOME)WIRES OF THE CONVERTER (MARKED 110VOLT 60HZ OUTPUT).
5. OPERATE THE JUKEBOX AS NORMAL.
ALL UNITS ARE PRESET AT 60HZ, BUT:-
6. SHOULD THE SPEED REQUIRE ADJUSTING;- USE A SMALL SCREWDRIVER THROUGH THE HOLE IN THE TOP OF THE UNIT, TURN THE CONTROL EITHER WAY TO INCREASE OR DECREASE SPEED AS REQUIRED.. A STROBE DISK MAY BE USED ON THE TURNTABLE TO ASSIST SETTING.
NOTE:- DO NOT DO THE ABOVE UNTIL THE JUKEBOX MOTOR IS FULLY WARMED UP(10 MINUTES PLAYING, AT LEAST)

WARNING DO NOT ATTEMPT TO POWER THE ENTIRE JUKEBOX FROM THE CONVERTER. DAMAGE WILL RESULT TO BOTH CONVERTER AND MAY DAMAGE THE JUKEBOX.
Back