INSTRUCTIONS FOR USE
50 to 60 CONVERTER
SEEBURG PLUG IN TYPE
MODELS B TO DS 1953- 61
1. OPEN THE BACK DOOR OF THE JUKEBOX.
2. LOCATE THE 11 PIN CIRCULAR PLUG, CONNECTING THE MECHANISM TO THE TORMAT SELECTION UNIT.
3. PULL OUT THE PLUG.
4. PLUG THE CONVERTER’S CABLE INTO THE SOCKET ON THE SELECTION UNIT.
5. PUSH THE MECHANISM PLUG INTO THE SOCKET OF THE CONVERTER’S CABLE.
6. SHOULD THE SPEED REQUIRE ADJUSTING,
USE A SMALL SCREWDRIVER THROUGH THE HOLE IN THE TOP OF THE UNIT, TURNING THE CONTROL EITHER WAY TO SPEED UP OR SLOW DOWN AS REQUIRED. A STROBE DISK MAY BE USED ON THE TURNTABLE TO ASSIST SETTING.
NOTE:- DO NOT DO THE ABOVE UNTIL THE JUKEBOX MOTOR IS FULLY WARMED UP(10 MINUTES PLAYING, AT LEAST)
7. PLACE THE UNIT IN THE BOTTOM OF THE JUKEBOX.
8. CLOSE THE BACK DOOR OF THE JUKEBOX.